Coal Model, Coal Figures and Models Made with Coal
Category :
Search :

Mallard - Coal Model Train Locomotive

Steam Train Model on Plinth with Name Plate

Featured in >


Image of Coal model - Mallard - Coal Model Train Locomotive | Steam Train Model on Plinth with Name Plate

This Coal model is: 7.50cm about 3 inches high

Not Currently In stock
Availability
Not in Currently in Stock Please Allow up to 15 days for restocking
Our stock code : CR1012

Mallard - Coal Model Train Locomotive coal mining collectable made with deep mined coal looks absolutely fantastic, appealing very much to the someone who places great emphasis on owning unusual and quality products.

Coal Model Dimensions
(Including base where applicable and measured at widest points)

  • Length 30.00 (cm) About 11 3/4 (inches) left to right
  • Height 7.50 (cm) About 3 (inches) top to bottom
  • Width 6.50 (cm) About 2 3/4 (inches) front to back

Coal Model Description

  • Hand Crafted product made from one of the most fascinating natural resources - coal
  • The model is Hand made and hand finished by ex coal miners.
  • Made in one single piece
  • Coated with a light lacquer to ensure quality and long life.
  • A fantastic figure and collectable coal model
  • Has been Hand Made with Crushed & Powdered Coal bound in protective resin

Have you also seen?

Fastest steam engine in the world (126mph), made from the same stuff that powered her to the record!

Number 4468 Mallard is a London and North Eastern Railway Class A4 4-6-2 Pacific steam locomotive built in the 1930s by the LNER and designed by Sir Nigel Gresley in Doncaster, England.
It was designed as an express locomotive with a wind-tunnel tested, aerodynamic body that allowed it to reach speeds of over 100 mph (160 km/h). It was in service until 1963 when it was retired after a lifetime distance of almost 1.5 million miles (2.4 million km). It was restored to working order in 1988 to celebrate its 50th anniversary, but as of September, 2003, it is out of service without a current boiler certificate. Mallard is now part of the national collection at the United Kingdom's National Railway Museum in York. Mallard is 70 ft long and weighs 165 tons.

Mallard is the holder of the world speed record for steam locomotives at 126 mph (203 km/h). The record was achieved on July 3, 1938 on the slight downwards grade of Stoke Bank south of Grantham on the East Coast Main Line, and the highest speed was recorded at milepost 90¼, between Little Bytham and Essendine. It broke the German 1936 record of 200.4 km/h (125 mph).

Mallard was the perfect vehicle for such an endeavour; one of the A4 class of streamlined locomotives designed for sustained 100+ mph (160 km/h) running, it was one of a small number equipped with a double chimney and double Kylchap blastpipe, which made for improved draughting and better exhaust flow at speed. The A4's three-cylinder design made for better stability at speed, and the large 6 ft 8 in (2.032 m) driving wheels meant that the maximum revolutions per minute was within the capabilities of the technology of the day.

Stoke Bank had a descending gradient of between 1:178 and 1:200. Mallard, with six coaches plus a dynamometer car in tow, topped Stoke Summit at 75 mph (121 km/h) and began to accelerate downhill. The speeds at the end of each mile (1.6 km) from the summit were recorded at: 87½, 96½, 104, 107, 111½, 116 and 119 mph (141, 155, 167, 172, 179, 187 and 192 km/h); half-mile (800 m) readings after that gave 120¾, 122½, 123, 124¼ and finally 125 mph (194, 197, 198, 200 and 201 km/h). The indicator diagrams on the dynamometer car traced a momentary maximum of 126 mph (203 km/h).

Shortly after the attainment of this record speed, Mallard suffered an overheated inside big end bearing and had to limp back to Doncaster for repair. Inaccuracies in the machining and setup of the Gresley-Holcroft derived motion (which derived the valve motion of the inside cylinder from those of the other two, avoiding a hard-to-maintain valve gear linkage between the frames) meant that the inside cylinder of the A4 did more work at high speed than the two outside cylinders; this overloading was mostly responsible for the failure.

Other coal models you may be interested in.


Other people interested in this coal model also looked at :


[ Top of page ]
Please be aware : that all our coal models and coal figurines are sold as ormaments or Gifts - for display purposes - they are not toys - because of the subject, they may have small parts that can be broken off, bitten off or break off when dropped - they should be kept away from children.

About the product images : these coal models and coal figurines are very black in colour and have a slight glossy appearance - sometimes we may have lightened the images a few shades to get the best level of detail on a wide range of computer screens.


 Finely detailed collectable coal figures are part of our fantastic range of coal models, coal ornaments and coal figurines
Copyright 2001 - 2017 Colliery Road - Contact - sales@collieryroad.com
Thank you for shopping at Colliery Road - www.collieryroad.com
[ Top of page ]
coal model figure miniature made with coal a finely detailed coal figure and unusual gifts ornaments and more at collieryroad.com